点击次数：

论文类型： 期刊论文

发表时间： 2012-03-01

发表刊物： JOURNAL OF MEMBRANE SCIENCE

收录刊物： SCIE、EI

卷号： 392

页面范围： 112-121

ISSN号： 0376-7388

关键字： Helical membrane; Fouling reduction; Turbulence enhancement; Average flux; Optimization

摘要： Membrane fouling can be greatly reduced by increasing the turbulence near membrane surfaces via enhancing aeration intensity or using helical baffles. A newly designed helical membrane served that purpose and achieved flux enhancement without increasing the aeration intensity or energy consumption. In this paper, the particle image velocimetry (PIV) technique was used to demonstrate the difference in intensity and distribution of flow field/velocity vectors between the helical and the flat sheet membrane modules. The results showed that the helical membrane produced rotational flows near the membrane surface and enhanced the shearing rate/flow velocity. To further optimize the membrane geometries (dimensions and angles) and investigate the influence of membrane spacing and membrane piece numbers in a helical membrane module on its performance in filtering sludge suspensions in membrane bioreactor (MBR), various membrane modules were studied. To the single piece membrane module of different dimensions, the average flux of a helical membrane was 17-37.5% higher than that of a flat membrane. The more slender membranes had better fouling reduction and higher flux enhancement. For multi-piece membrane module, 8 piece helical module enjoyed more favorable flow dynamics, great fouling reductions and an enhancement of the average flux over 50% than the 8 piece flat module. An appropriate spacing and a lower trans-membrane pressure (TMP) was important for achieving higher permeate flux, and the use of flocculants significantly increased the sludge permeability and the permeate flux using the helical membrane in MBR. (C) 2011 Elsevier B. V. All rights reserved.