location: Current position: Home >> Scientific Research >> Paper Publications

An application scheme of LIBS to detect trace ethanol and methanol

Hits:

Indexed by:期刊论文

Date of Publication:2014-12-01

Journal:VACUUM

Included Journals:EI、SCIE、ISTIC

Volume:110

Issue:,SI

Page Number:221-227

ISSN No.:0042-207X

Key Words:Laser-induced breakdown spectroscopy; Alcohol; Quantitative detection; Molecular identification

Abstract:Laser Induced Breakdown Spectroscopy (LIBS) is an alternative tool for chemical analysis of any given solid and liquid samples, especially of in-organic materials. If a reliable calibration can be performed, the technique is also acceptable for elemental quantitative analysis. However, LIBS has not been widely applied for organic chemical analysis, especially for organic molecular identification, although some trial investigations have been reported. In this paper, a scheme for detection and identification of trace methanol and ethanol using LIBS is reported. In the scheme, an intensive pulsed laser is used to breakdown gaseous trace alcohol samples and the optical emission spectra of the induced plasma are collected. In order to verify the scheme, trace alcohol samples are prepare deliberately by using pure ethanol or methanol bubbled with Argon as carrier gas and then mixed into matrix gases. The key issue for the scheme is to constitute indexes from the LIBS data. Two indexes are found suitable for alcohol detection and identification. One is the emission intensity ratio (as H/C) of the Hydrogen line (653.3 nm) to Carbon line (247.9 nm) for identification and the other is the ratio of the Carbon line (as C/Ar) or the Hydrogen line (as H/Ar) to Argon lines (866.7 nm) for quantitative detection. Calibration experiment result shows the index H/C is specific for the two congeners but almost independent on concentration. In detail, the H/C keeps specific constant of 34 and 23 respectively for ethanol and methanol. Calibration of the indexes C/Ar and H/Ar shows they are almost linearly related to concentration below 1300 ppm and therefore are competent for concentration measurement. With the indexes, trace concentration measurement achieves a limit of 140 ppm using laser pulse energy of 300 mJ. (C) 2014 Elsevier Ltd. All rights reserved.

Pre One:Numerical study of the effects of physical parameters on the dynamic fuel retention in tungsten materials

Next One:太阳能集热管涂层关键技术进展