location: Current position: Home >> Scientific Research >> Paper Publications

Experimental study on combustion characteristics of Chinese RP-3 kerosene

Hits:

Indexed by:期刊论文

Date of Publication:2016-04-01

Journal:CHINESE JOURNAL OF AERONAUTICS

Included Journals:SCIE、EI、ISTIC

Volume:29

Issue:2

Page Number:375-385

ISSN No.:1000-9361

Key Words:Combustion mechanism; Combustion stability; Laminar combustion speed; Markstein length; RP-3 kerosene

Abstract:In order to illustrate the combustion characteristics of RP-3 kerosene which is widely used in Chinese aero-engines, the combustion characteristics of RP-3 kerosene were experimentally investigated in a constant volume combustion chamber. The experiments were performed at four different pressures of 0.1 MPa, 0.3 MPa, 0.5 MPa and 0.7 MPa, and three different temperatures of 390 K, 420 K and 450 K, and over the equivalence ratio range of 0.6-1.6. Furthermore, the laminar combustion speeds of a surrogate fuel for RP-3 kerosene were simulated under certain conditions. The results show that increasing the initial temperature or decreasing the initial pressure causes an increase in the laminar combustion speed of RP-3 kerosene. With the equivalence ratio increasing from 0.6 to 1.6, the laminar combustion speed increases initially and then decreases gradually. The highest laminar combustion speed is measured under fuel rich condition (the equivalence ratio is 1.2). At the same time, the Markstein length shows the same changing trend as the laminar combustion speed with modification of the initial pressure. Increasing the initial pressure will increase the instability of the flame front, which is established by decreased Markstein length. However, different from the effects of the initial temperature and equivalence ratio on the laminar combustion speed, increasing the equivalence ratio will lead to a decrease in the Markstein length and the stability of the flame front, and the effect of the initial temperature on the Markstein length is unclear. Furthermore, the simulated laminar combustion speeds of the surrogate fuel agree with the corresponding experimental datas of RP-3 kerosene within similar to 10% deviation under certain conditions. (C) 2016 Chinese Society of Aeronautics and Astronautics. Published by Elsevier Ltd.

Pre One:Three-dimensional numerical investigation on wall film formation and evaporation in port fuel injection engines

Next One:Towards a comprehensive understanding of the influence of fuel properties on the combustion characteristics of a RCCI (reactivity controlled compression ignition) engine