点击次数：

论文类型：期刊论文

发表时间：2011-01-01

发表刊物：ACOUSTICAL PHYSICS

收录刊物：SCIE、EI

卷号：57

期号：1

页面范围：114-120

ISSN号：1063-7710

摘要：This paper presents an investigation of the process factors affecting the surface roughness in ultra-precision diamond turning with ultrasonic vibration. Stainless steel was turned by diamond tools with ultrasonic vibration applied in the feed direction with an auto-resonant control system. Surface roughness was measured and compared along with the change of the cutting parameters. The relation curves between the cutting parameters and surface roughness were achieved by comparing the experimental results with different cutting speeds, feed rates, cutting depths. Experimental results indicate that cutting parameters have an obvious effect on the surface roughness. The conclusions are draw in given conditions, the smaller amplitude of the vibration, the worse the surface quality and the higher vibrating frequency, the better surface quality, and the deeper the cutting depth and the more the feed rate, the worse the surface quality. Among these parameters, the feed rate was the most important factor on surface quality.