location: Current position: Home >> Scientific Research >> Paper Publications

CO2 conversion in non-thermal plasma and plasma/g-C3N4 catalyst hybrid processes

Hits:

Indexed by:期刊论文

Date of Publication:2018-03-07

Journal:JOURNAL OF PHYSICS D-APPLIED PHYSICS

Included Journals:SCIE、EI

Volume:51

Issue:9

ISSN No.:0022-3727

Key Words:CO2 conversion; non-thermal plasma; G-C3N4-based catalysts; gas temperature

Abstract:Carbon dioxide conversion at atmosphere pressure and low temperature has been studied in a cylindrical dielectric barrier discharge (DBD) reactor. Pure CO2 feed flows to the discharge zone and typical filamentary discharges were obtained in each half-cycle of the applied voltage. The gas temperature increased with discharge time and discharge power, which was found to affect the CO2 decomposition deeply. As the DBD reactor was cooled to ambient temperature, both the conversion of CO2 and the CO yield were enhanced. Especially the energy efficiencies changed slightly with the increase of discharge power and were much higher in cooling condition comparing to those without cooling. At a discharge power of 40 W, the energy efficiency under cooling condition was approximately six times more than that without cooling. Gas flow rate was observed to affect CO2 conversion and 0.1 L min(-1) was obtained as optimum gas flow rate under cooling condition. In addition, the CO2 conversion rate in plasma/g-C3N4 catalyst hybrid system was twice times as that in plasma-alone system. In case of cooling, the existence of g-C3N4 catalyst contributed to a 47% increase of CO2 conversion compared to the sole plasma process. The maximum energy-efficiency with g-C3N4 was 0.26 mmol kJ(-1) at 20 W, which increased by 157% compared to that without g-C3N4. The synergistic effect of DBD plasma with g-C3N4 on pure CO2 conversion was verified.

Pre One:A comparative study on the activity of TiO2 in pulsed plasma under different discharge conditions

Next One:新型放射针状环绕接地技术研究及应用