Hits:

Indexed by:期刊论文

Date of Publication:2017-04-01

Journal:INTERNATIONAL JOURNAL OF HEAT AND MASS TRANSFER

Included Journals:SCIE、EI

Volume:107

Page Number:1028-1034

ISSN No.:0017-9310

Key Words:Horizontal tube; Two-phase; Flow behaviour; Film thickness distribution; 3-D model

Abstract:The behaviour of falling film has significant effects on the efficiency of heat and mass transfer. Therefore it is important to study on the distribution of the film thickness around a tube in both the circumferential and axial directions. A 3-D model was applied in this study to simulate the falling film flow process of a column flow outside a horizontal tube, of which the Reynolds number varied from approximately 171 to 368. The results showed that with a single liquid column, a saddle-shaped spreading liquid lamella was formed along the axial direction, and the maximum elongation distance of the liquid film was obtained in the axial direction. In contrast, with two adjacent liquid columns, the flow behaviour changed a lot due to the interaction between the columns. A crest was formed between the two columns, and the maximum film thickness was more than three times of the minimum in the axial direction. In addition, the film thickness in the central section of the liquid column was extracted. It rapidly decreased as the circumferential angle varied from 20 degrees to 60 degrees. Then it changed little in the range of 60-120 degrees, and sharply increased in the range of 120-150 degrees. (C) 2016 Elsevier Ltd. All rights reserved.