点击次数：

论文类型：期刊论文

发表时间：2018-02-01

发表刊物：APPLIED SCIENCES-BASEL

收录刊物：SCIE

卷号：8

期号：2

ISSN号：2076-3417

关键字：angular indexing error; gear measurement; coaxiality error; positioning of centers; error compensation

摘要：In gear measuring machines (GMMs), the tested gear is mounted on a mandrel, which is pivoted at both ends by two centers in a vertical arrangement. The upper center is fixed and the lower center is driven by the spindle of rotation. The coaxiality error between the central line of the mandrel and the spindle average line of a GMM always exists in terms of the offset and angle measured in one plane. Such a coaxiality error would cause an angular indexing error of tested gear resulting in measurement error. This phenomenon has rarely been investigated. In this paper, a GMM is taken as an example and its coaxiality error of the mandrel and spindle error of the rotary stage are measured. The difference of rotated angles between the mandrel and spindle is theoretically analyzed by derived formulae. Calibrated by a precision polygon and an autocollimator, the predicted angular index error of the mandrel was consistent with experimental results. Through the experimental verification, it was found that, when the coaxial deviation between the two centers was 10 m and the lower center tip's radial motion error was 1.6 mu m, the angular indexing deviation of the mandrel was +/- 5 ''. If the errors were compensated according to the analyzed model, the residual error was reduced to +/- 2 ''. A significant improvement in the angular positioning accuracy of the GMM can be achieved.