Hits:

Indexed by:期刊论文

Date of Publication:2016-04-05

Journal:MATERIALS & DESIGN

Included Journals:SCIE、EI

Volume:95

Page Number:89-96

ISSN No.:0264-1275

Key Words:Metal-matrix composites; Woven carbon fiber; Liquid rolling process; Finite-element simulation; Mechanical property

Abstract:A liquid rolling method was successfully developed for the fabrication of woven carbon fibers reinforced Al5083-matrix composites. The woven fibers were coated with Ni/P to facilitate wetting of the fibers by the molten matrix. It was found that the composite fabricated in this way had a good microstructure with few defects, which was most likely due to the occurrences of pressure infiltration, rapid solidification, and hot-deformation strengthening on the materials. Finite-element simulation was conducted to analyze the temperature field and solidification process during the liquid rolling. A wide semi-solid region was observed in the simulation, and it would effectively avoid the fiber damages. The results of three-point bending measurements implied that the application of liquid rolling and the addition of reinforcements could both offer obvious improvements to the materials. The liquid rolling method could increase the matrix bending strength by 43% than the casting method. Furthermore, when the liquid rolling was used, the addition of woven fibers could offer an improvement of 22% to the matrix. (C) 2016 Elsevier Ltd. All rights reserved.