点击次数：

论文类型：期刊论文

发表时间：2009-09-21

发表刊物：Materials Science Forum

收录刊物：EI、CPCI-S、Scopus

卷号：628 629

页面范围：423-428

ISSN号：0878493123

关键字：Fuel cell; MEMS; Flow-field plate; Microfabrication

摘要：This paper presents the design, microfabrication and characterizations of a silicon based, single-cell μDMFC demonstrator for micro/portable electrical power applications. The flow field plates of the fuel cell were made on 2'silicon wafers utilizing wet-etching and sputtering techniques. The fuel cell was assembled in an epoxy-based packaging process. Results show that a lower internal ohmic resistance of the fuel cell can be achieved with a thicker current collecting layer (CCL). Influence of the operating conditions on the μDMFC performance was also investigated. It was found that 2M methanol can yield a better fuel cell performance because it provided a better compromise between the methanol crossover and mass transportation during operation. On the other hand, a 4-time increase of the peak power density of the fuel cell was achieved by increasing the methanol temperature from 20°C to 80°C. © (2009) Trans Tech Publications, Switzerland.