论文成果
联系我们
连志强老师:电话:18641181139

电邮:lianzq75@dlut.edu.cn
当前位置: 中文主页 >> 研究成果 >> 论文成果
Influence of salt content on clay electro-dewatering with copper and stainless steel anodes
发表时间:2019-11-01 点击次数:
论文类型:期刊论文
第一作者:Xue, Zhijia
通讯作者:Zhang, Y (reprint author), Xian Univ Technol, Sch Civil Engn & Architecture, Xian 710048, Shaanxi, Peoples R China.
合写作者:Tang, Xiaowei,Yang, Qing,Tian, Zhifeng,Zhang, Yao
发表时间:2019-11-18
发表刊物:DRYING TECHNOLOGY
收录刊物:EI、SCIE
文献类型:J
卷号:37
期号:15
页面范围:2005-2019
ISSN号:0737-3937
关键字:Catch point; copper anode; electro-dewatering; stainless steel anode
摘要:The electro-dewatering technique is an effective method to reinforce soft clay. Electro-dewatering experiments were conducted to assess the impact of salt content on electro-dewatering behaviors and effects with copper and stainless steel anodes. The changes in the current, accumulated drainage volume, and electro-osmotic flow velocity reflect the "catch point" phenomenon between the copper anode and the stainless steel anode. Moreover, the higher the salt content was, the earlier the appearance of the "catch point," which means that the effect of the copper anode was better in the early stages and then worse in the following stages than that of the stainless steel anode. Based on photographs of anode surface, SEM-EDS (Scanning electron microscopy-Energy dispersive spectrometry) and XRD (X-ray diffraction) results, we found that the copper anode surface produced green product, which observably decreased the conductivity of the copper anode and then reduced the effective electrical potential gradient. On the other hand, there were no added elements on the stainless steel anode surface after the electro-dewatering experiments, and the conductivity of the stainless steel anode was similar to its initial status. The above two points led to the appearance of the"catch point" phenomenon. The pH value of the stainless steel anode was lower than that of copper anode, and the concentration of Cl- had the opposite relationship. Because the effective electrical potential gradient of the stainless steel anode was higher than that of the copper anode after the "catch point," the water content of the stainless steel anode was lower than that of the copper anode.
是否译文: