点击次数：

论文类型：期刊论文

发表时间：2013-12-01

发表刊物：SENSORS AND ACTUATORS A-PHYSICAL

收录刊物：SCIE、EI、Scopus

卷号：203

页面范围：355-361

ISSN号：0924-4247

关键字：Strain sensor; Coaxial cable; Impedance discontinuity; S parameter; Structural condition monitoring; Sensitivity

摘要：Strain sensors have been used extensively in structural condition monitoring. In this paper, based upon microwave network theory, a novel design method for a real-time strain monitoring sensor is proposed by using the variable cross section of a coaxial cable to detect the strain-induced frequency shift of the peak frequency at which the S parameter exhibits a peak value. With this method, a dual variable-cross-section sensor is designed and fabricated using coaxial cable as the fabrication element. The S-parameters of the sensor obtained analytically by transmission theory are almost consistent with those obtained by numerical simulation. In experiments, the sensitivity of the sensor achieved 5 MHz/m epsilon with the original segment length of 10.345 mm and peak frequency of 5.0 GHz, and the resolution achieved is 140.25 mu epsilon. The relative small deviation of nearly 3.2% from the theoretical results to the experimental results adequately validated the feasibility of the design method. Adjusting the diameter of the dielectric layer, the length and cascaded periods of the variable cross-section, the quality factor and sensitivity of the sensor can be optimized. Due to the simplicity and ruggedness of the cable based sensor it has great potential application in structural condition monitoring compared to existing sensors. (C) 2013 Elsevier B.V. All rights reserved.