点击次数：

论文类型：期刊论文

发表时间：2019-11-15

发表刊物：ENGINEERING STRUCTURES

收录刊物：EI、SCIE

卷号：199

ISSN号：0141-0296

关键字：Composite joints; Steel-reinforced recycled concrete columns; Steel beams; Recycled aggregate concrete; Cyclic loading

摘要：Cyclic loading tests were conducted for eight composite joints (five interior joints and three exterior joints) with steel-reinforced recycled concrete (SRRC) columns and steel beams under cyclic loading. The axial compression ratio and recycled coarse aggregate (RCA) replacement percentage were considered as the main design parameters for the above composite joints. The failure process, failure modes, hysteresis loops, skeleton curves, stiffness degradation, storey drift ratio, bearing capacity, ductility and energy dissipation capacity of the joints were presented and analysed in detail. The influence of the design parameters on the mechanical performance of the composite joints under cyclic loading was also investigated. Results showed that the cracking loads of the joints increased with the increase of axial compression ratio. Typical shear failure was the failure mode. The spindle-shaped hysteresis loops of the joints, the ductility coefficients, the elastic-plastic storey drift ratios and the equivalent viscous damping coefficients indicated a relatively good seismic performance. The bearing capacity and stiffness of the joints decreased gradually, while the ductility and energy dissipation capacity of the joints decreased slightly with an increase in the RCA replacement percentage. Additionally, the stiffness degradation of the composite joints accelerated and the energy dissipation capacity and ductility reduced evidently with an increase in the axial compression ratio. Finally, a comparative analysis of each shear strength formula was conducted. The result showed that the formulas of ASCE, AU and JGJ138-2001 could predict the shear strength of the joints accurately. This validation indicated that the existing methods are applicable to this group of composite joints.