张博

(教授)

 博士生导师  硕士生导师
学位:博士
性别:男
毕业院校:大连理工大学
所在单位:能源与动力学院
电子邮箱:zhangbo@dlut.edu.cn

论文成果

当前位置: 中文主页 >> 科学研究 >> 论文成果

Experimental investigation of surface temperature non-uniformity in spray cooling

发表时间:2019-11-07 点击次数:

论文名称:Experimental investigation of surface temperature non-uniformity in spray cooling
论文类型:期刊论文
发表刊物:INTERNATIONAL JOURNAL OF HEAT AND MASS TRANSFER
收录刊物:EI、SCIE
卷号:146
ISSN号:0017-9310
关键字:Temperature non-uniformity; Surface heat transfer; Spray cooling; Inverse heat conduction
摘要:The surface temperature non-uniformity is crucial in understanding the heat transfer mechanism of spray cooling. It is also a sensitive factor in the thermal management of electronic devices or in the application of transient sprays where the surface heat flux is obtained from the internal temperature measurement. In this study, the effects of heat flux, subcooling, nozzle-to-surface height, and injection pressures on the surface temperature uniformity in a spray cooling application were studied. The distribution of droplet diameter and the spray volumetric flux was found to significantly vary under the above experimental conditions. A higher spray volumetric flux and smaller droplet diameter resulted in a lower surface temperature. In general, the spray volumetric flux is the dominant parameter. The effect of droplet diameter distribution always became obvious with low spray volumetric flux. Regarding the high spray volumetric flux, there was an offset between these two parameters. The results also indicated that increasing the heat flux, nozzle-to-surface height, and subcooling, as well as decreasing the inlet pressure, all resulted in higher surface temperature uniformity owing to the variation in the droplet diameter and spray volumetric flux distributions. Finally, prediction methods for temperature non-uniformity were proposed for single-phase and two-phase regimes. (C) 2019 Elsevier Ltd. All rights reserved.
发表时间:2020-01-01