扫描手机二维码

欢迎您的访问
您是第 位访客

开通时间:..

最后更新时间:..

  • 贾明 ( 教授 )

    的个人主页 http://faculty.dlut.edu.cn/jiaming/zh_CN/index.htm

  •   教授   博士生导师   硕士生导师
  • 主要任职:图书馆馆长
专著 当前位置: 中文主页 >> 科学研究 >> 专著
Multi-objective optimization of the combustion of a heavy-duty diesel engine with low temperature combustion under a wide load range: (I) Computational method and optimization results

点击次数:
论文类型:期刊论文
发表时间:2017-05-01
发表刊物:ENERGY
收录刊物:SCIE、EI
卷号:126
页面范围:707-719
ISSN号:0360-5442
关键字:Low temperature combustion (LTC); Wide load range; Control strategy; Nitrogen oxides (NOx) emissions; Thermal efficiency
摘要:By coupling a multi-dimensional computational fluid dynamics (CFD) code with genetic algorithm (GA), the combustion of a heavy-duty diesel engine with LTC (low temperature combustion) was optimized under a wide load range. At each load, a comprehensive optimization of the operating parameters including IVC (intake valve closing) timing, SOI (start of injection) timing, EGR (exhaust gas recirculation) rate, the initial in-cylinder pressure and temperature at IVC was conducted in order to simultaneously minimize ISFC (indicated specific fuel consumption), NOx (nitrogen oxides) and soot emissions, and seek the optimal control strategies. Furthermore, by employing the one-dimensional simulation, the correlation between the initial in-cylinder conditions at IVC and the intake conditions was developed. The optimization results indicate that the range of the operating parameters narrows considerably with increasing load. At low load, both early and late IVC timing can be employed. As late IVC is introduced, high intake pressure and high EGR rate up to 70% are needed to realize low NOx emissions, whereas low intake pressure and moderate EGR rate (around 40%) are necessary for early IVC. For both late and early IVC, the optimal SOI timing is 10-20 degrees CA BTDC (before top dead center) at low load to simultaneously avoid serious spray/wall impingement and diffusion combustion. At mid load, IVC timing should be advanced to 104-110 degrees CA BTDC with a moderate EGR rate (40%-50%) and slightly high intake pressure, and SOI is similar with that of low load. In contrast, at high load, the optimal IVC timing is fixed at around 114 degrees CA BTDC and EGR rate is reduced to about 20%, while a late SOI (2.9 CA degrees ATDC) is needed to avoid overly high in-cylinder peak pressure and pressure rise rate. (C) 2017 Elsevier Ltd. All rights reserved.

 

辽ICP备05001357号 地址:中国·辽宁省大连市甘井子区凌工路2号 邮编:116024
版权所有:大连理工大学