扫描手机二维码

欢迎您的访问
您是第 位访客

开通时间:..

最后更新时间:..

  • 贾明 ( 教授 )

    的个人主页 http://faculty.dlut.edu.cn/jiaming/zh_CN/index.htm

  •   教授   博士生导师   硕士生导师
  • 主要任职:图书馆馆长
专著 当前位置: 中文主页 >> 科学研究 >> 专著
An enhanced multi-component vaporization model for high temperature and pressure conditions

点击次数:
论文类型:期刊论文
发表时间:2015-11-01
发表刊物:INTERNATIONAL JOURNAL OF HEAT AND MASS TRANSFER
收录刊物:SCIE、EI、Scopus
卷号:90
页面范围:857-871
ISSN号:0017-9310
关键字:Vaporization; Multi-component droplet; Radiation absorption; High pressure
摘要:An enhanced multi-component vaporization model was proposed to simulate the vaporization process of fuel droplets under high ambient temperatures and pressures. In the present model, the heat flux of conduction, enthalpy diffusion, and radiation absorption in the gas phase are calculated by Fourier's law, the multi-component diffusion sub-model, and a simplified analytical solution of the radiative heating, respectively. A surface temperature sub-model was employed to evaluate the average temperature within the droplet and the surface temperature of the droplet. For calculation of vapor-liquid phase equilibrium, a real and an ideal gas approach was used for high and low ambient temperatures and pressures, respectively. Moreover, the dependence of gas physical properties on temperature and pressure is also considered. Based on the enhanced vaporization model, extensive verifications for different multi-component droplets were conducted, and the results indicate that satisfactory agreements between the predictions and measurements can be achieved. Finally, the multi-component vaporization model was applied to investigate the vaporization characteristics of practical fuel droplets with a wide range of diameters at high ambient temperatures and pressures, and the effects of radiation absorption and real gas behavior on the vaporization process were understood. It is found that the influence of radiation absorption on the vaporization behavior strongly depends on the droplet diameter and the ambient temperature, and the effect of ambient pressure on the average vaporization rate is determined by the ambient temperature. Considering the compromise between computational accuracy and efficiency, a pressure criterion (P') was introduced for the choice of ideal or real gas approaches, and a diameter criterion (D') was also defined to decide whether to consider the radiation absorption in the vaporization model. (C) 2015 Elsevier Ltd. All rights reserved.

 

辽ICP备05001357号 地址:中国·辽宁省大连市甘井子区凌工路2号 邮编:116024
版权所有:大连理工大学