李爱民

个人信息Personal Information

教授

博士生导师

硕士生导师

性别:男

毕业院校:浙江大学

学位:博士

所在单位:环境学院

学科:环境工程. 热能工程

办公地点:环境学院211

联系方式:0411-84707448

电子邮箱:leeam@dlut.edu.cn

扫描关注

论文成果

当前位置: 中文主页 >> 科学研究 >> 论文成果

Hydrothermal treatment coupled with mechanical expression at increased temperature for excess sludge dewatering: Influence of operating conditions and the process energetics

点击次数:

论文类型:期刊论文

发表时间:2014-11-15

发表刊物:WATER RESEARCH

收录刊物:SCIE、EI、PubMed、Scopus

卷号:65

页面范围:85-97

ISSN号:0043-1354

关键字:Excess sludge; Hydrothermal treatment; Mechanical expression; Filtrate; Energy-efficiency

摘要:Dewatering is very important for excess sludge treatment and disposal. Hydrothermal treatment coupled with mechanical expression is a novel technology, in which a conventional pressure dewatering is combined with hydrothermal effect to realize an improved liquid/solids separation with low energy consumption. In this study, the process was performed by way of that the excess sludge was hydrothermally treated first and then the mechanical expression was employed immediately at increased temperature in two separate cells respectively. The results demonstrated that the mechanical expression employed at increased temperature showed a significant advantage than that at room temperature, given a further reduction of 19-47% of the moisture content. The dewatering process at room temperature was mostly depended on the effect of mechanical expression. Hydrothermal process, more importantly than mechanical effect at increased temperatures, seemed to govern the extent to which the dewatering process occurred. The dewatering began to show a positive effect when the temperature was exceeded the threshold temperature (between 120 and 150 degrees C). The residence time of 30 min promoted a substantial conversion in the sludge surface properties. After dewatering at temperatures of 180-210 degrees C, the moisture content decreased from 52 to 20% and the corresponding total water removal as filtrate was between 81 and 93%. It was observed that the moisture content of filter cake correlated with surface charge (R-p = -0.93, p < 0.05) and relative hydrophobicity (R-p = -0.99, p < 0.05). The calculated energy balance suggested that no additional external energy input is needed to support the dewatering process for excess sludge. The dewatering process needs an obviously lower energy input compared to thermal drying and electro-dewatering to produce a higher solids content cake. (C) 2014 Elsevier Ltd. All rights reserved.