个人信息Personal Information
副教授
博士生导师
硕士生导师
性别:男
毕业院校:大连理工大学
学位:博士
所在单位:化工学院
学科:安全科学与工程. 化工过程机械
电子邮箱:mengxiangyu@dlut.edu.cn
Diesel-Like Efficiency Using Compressed Natural Gas/Diesel Dual-Fuel Combustion
点击次数:
论文类型:期刊论文
发表时间:2016-09-01
发表刊物:JOURNAL OF ENERGY RESOURCES TECHNOLOGY-TRANSACTIONS OF THE ASME
收录刊物:SCIE
卷号:138
期号:5
ISSN号:0195-0738
摘要:The use of natural gas in compression ignition (CI) engines as a supplement to diesel under dual-fuel combustion mode is a promising technique to increase efficiency and reduce emissions. In this study, the effect of dual-fuel operating mode on combustion characteristics, engine performance and pollutant emissions of a diesel engine using natural gas as primary fuel and neat diesel as pilot fuel, has been examined. Natural gas (99% methane) was port injected into an AVL 5402 single cylinder diesel research engine under various engine operating conditions and up to 90% substitution was achieved. In addition, neat diesel was also tested as a baseline for comparison. The experiments were conducted at three different speeds-1200, 1500, and 2000 rpm, and at different diesel-equivalent loads (injection quantity)-15, 20 (7 bar IMEP), and 25 mg/cycle. Both performance and emissions data are presented and discussed. The performance was evaluated through measurements of in-cylinder pressure, power output and various exhaust emissions including unburned hydrocarbons (UHCs), carbon monoxide (CO), nitrogen oxides (NOx), and soot. The goal of these experiments was to maximize the efficiency. This was done as follows-the compressed natural gas (CNG) substitution rate (based on energy) was increased from 30% to 90% at fixed engine conditions, to identify the optimum CNG substitution rate. Then using that rate, a main injection timing sweep was performed. Under these optimized conditions, combustion behavior was also compared between single, double, and triple injections. Finally, a load and speed sweep at the optimum CNG rate and timings were performed. It was found that a 70% CNG substitution provided the highest indicated thermal efficiency (ITE). It appears that dual-fuel combustion has a maximum brake torque (MBT) diesel injection timing for different conditions which provides the highest torque. Based on multiple diesel injection tests, it was found that the conditions that favor pure diesel combustion, also favor dual-fuel combustion because better diesel combustion provides better ignition and combustion for the CNG-air mixture. For 70% CNG dual-fuel combustion, multiple diesel injections showed an increase in the efficiency. Based on the experiments conducted, diesel-CNG dual-fuel combustion is able to achieve similar efficiency and reduced emissions relative to pure diesel combustion. As such, CNG can be effectively used to substitute for diesel fuel in CI engines.