• 更多栏目
    • 语种

    欧进萍

    • 教授     博士生导师   硕士生导师
    • 性别:男
    • 毕业院校:哈尔滨建筑大学
    • 学位:博士
    • 所在单位:建设工程学院
    • 电子邮箱:ojinping@dlut.edu.cn

    访问量:

    开通时间:..

    最后更新时间:..

    Fracture and self-sensing characteristics of super-fine stainless wire reinforced reactive powder concrete

    点击次数:

    论文类型:期刊论文

    发表时间:2020-01-01

    发表刊物:CEMENT & CONCRETE COMPOSITES

    收录刊物:EI、SCIE

    卷号:105

    ISSN号:0958-9465

    关键字:Super-fine stainless wire; Reactive powder concrete; Fracture toughness; Fracture energy; Fracture self-sensing

    摘要:Super-fine stainless wire (SSW) can not only form widely distributed enhancing, toughening and conductive network in reactive powder concrete (RPC) at low dosage level, but also improve weak interface area and refine cracks due to its micron scale diameter and large specific surface. In addition, the crack resistance zone generated by SSWs and RPC matrix together has potential to further enhance the fracture properties of composites. Therefore, fracture and self-sensing characteristics of SSW reinforced RPC composites were investigated in this paper. Experimental results indicated that adding 1.5 vol % of SSW leads to 183.1% increase in the initial cracking load of RPC specimens under three-point bending load. Based on two parameter fracture model calculations, an increase of 203.4% in fracture toughness as well as an increase of 113.3% in crack tip opening displacement of the composites reinforced with 1.5% SSWs is achieved. According to double-K fracture model calculations, the initiation fracture toughness and unstable fracture toughness of the composites are enhanced by 185.2% and 179.2%, respectively. The increment for fracture energy of the composites reaches up to 1017.1% because of the emergence of blunt and tortuous cracks. The mixed mode I-II fracture toughness of the composites is increased by 177.1% under four-point shearing load. The initial angle of mixed mode I-II cracks of the composites decreases with the increase of SSW content. The initiation and propagation of cracks in the composites can be monitored by their change in electrical resistivity. The excellent fracture toughness of the composites is of great significance for the improvement of structure safety in serviceability limit states, and the self-sensing ability of the composites can also provide early warning for the degradation of structure safety.