![]() |
个人信息Personal Information
教授
博士生导师
硕士生导师
性别:男
毕业院校:大连理工大学
学位:硕士
所在单位:化工学院
学科:化学工艺. 能源化工
办公地点:大连理工大学西部校区化工实验楼C-327
联系方式:微信号:ZQM589X
电子邮箱:zhangqm@dlut.edu.cn
The influence of abundant calcium oxide addition on oil sand pyrolysis
点击次数:
论文类型:期刊论文
发表时间:2016-01-01
发表刊物:International Conference on Coal Science and Technology (ICC and T) / Australia-China Symposium on Energy (ACSE)
收录刊物:SCIE、EI、CPCI-S、Scopus
卷号:155
期号:,SI
页面范围:216-224
ISSN号:0378-3820
关键字:Oil sand; Pyrolysis; Calcium oxide; Pyrolysis kinetics; Bitumen upgrading
摘要:The influence of abundant calcium oxide (CaO) addition on oil sand pyrolysis was firstly studied by thermo-gravimetric analysis (TGA) and in a fixed bed reactor. CaO additives calcined from analytically pure CaCO3 (named A) and oil sand minerals (named B) were compared with the addition ratio at 1:1 (oil sand:Ca, mass ratio). Observed by TGA, abundant addition of CaO would inhibit the devolatilizing during oil-producing stage (150-600 degrees C). However, higher temperature appeared to weaken the inhibition effects. Comparison of pyrolysis in the fixed bed reactor was at 480 degrees C, 140 mL/min pure N-2 carrier gas, 0.1 MPa for 40 min. When pyrolyzed with abundant CaO, the gas yields (including H2S and COS) decreased which met the result of TG/MS analysis. Tiny differences were found on tar yields which achieved around 88% of raw bitumen. But through column chromatography and gas chromatography/mass spectrometry (GC/MS) analysis, the proportion of aliphatic fraction increased, interestingly observing more alkanes with long carbon chain and less olefins. The proportion of aromatic fraction decreased by about 10 wt%, but the relative amount of polycyclic aromatic hydrocarbon (PAHs) got an obvious increase when pyrolyzed oil sand with abundant CaO. As expected, acidic compounds in resin (e.g. phenols and carboxylic acids) were significantly reduced. In general, it was both physically and catalytically that abundant addition of CaO influence on oil sand pyrolysis. But no evident differences between additive A and additive B were found on yields and product compositions. (C) 2016 Elsevier B.V. All rights reserved.