余隽

  • 副教授     博士生导师   硕士生导师
  • 任职 : 仪器仪表学会传感器分会理事;中国仪器仪表学会微纳器件与系统技术分会理事;IEEE会员
  • 性别:女
  • 毕业院校:大连理工大学
  • 学位:博士
  • 所在单位:生物医学工程学院
  • 学科:微电子学与固体电子学. 生物医学工程. 电路与系统
  • 电子邮箱:junyu@dlut.edu.cn

访问量:

开通时间:..

最后更新时间:..

Electrohydrodynamic inkjet printing of Pd loaded SnO2 nanofibers on a CMOS micro hotplate for low power H-2 detection

点击次数:

论文类型:期刊论文

第一作者:Wu, Hao

通讯作者:Yu, J (reprint author), Dalian Univ Technol, Fac Elect Informat & Elect Engn, Key Lab Liaoning Integrated Circuits Technol, Dalian 116024, Peoples R China.

合写作者:Yu, Jun,Cao, Rui,Yang, Yinghua,Tang, Zhenan

发表时间:2018-05-01

发表刊物:AIP ADVANCES

收录刊物:SCIE

卷号:8

期号:5

ISSN号:2158-3226

摘要:A high-performance low-power micro hotplate (MHP) hydrogen sensor was fabricated through electrohydrodynamic (EHD) inkjet printing technique. Electrospun Pd loaded SnO2 nanofibers with lengths of 250-850 nm were precisely printed on the suspended central part of an MHP with an area of 100 um x 100 um. The printhead in the printing system was a low-cost metallic needle with an inner diameter of 110 um, which was large enough to prevent clogging by the nanofibers. The printing process was observed by a high-speed camera. Small droplets with diameters of 50-80 um were produced at each ejection by providing a high voltage to the metallic needle. It was found that the bridge-type MHPs used in our experiment can promote the positioning precision due to its bound effect to the droplet. In the gas sensing measurement, the Pd loaded SnO2 MHP gas sensor showed a remarkable response to H-2 with a low power of only 9.1 mW. The experiment results demonstrate the excellent adequacy of EHD inkjet printing technique to realize effective mass fabrication of MHP gas sensors or sensor arrays. (C) 2018 Author(s).