Hits:

Indexed by:会议论文

Date of Publication:2011-12-16

Included Journals:EI、CPCI-S、Scopus

Volume:415-417

Page Number:66-70

Key Words:profile modification; contact force; ways of gear relief; relief curve; ANSYS/LS-DYNA

Abstract:An accurate finite element contact analysis of helical gears was done directly under ANSYS, while the integrated elastic deformation of the meshed teeth was extracted directly from the finite element contact analysis results, and considered as the main basis of the amount of tooth profile modification. Linear, conic, cubic, and sine relief curve are compiled and established in MATLAB, on which gear models of two ways of modified gear are built. Under the same modified parameters, contact method is used on the proposed finite element models of gears by software LS-DYNA, and the effect of the two ways of gear relief on contact force on teeth face is analyzed. The results show that the effect of a pair of gears relief is better than one gear relief for linear and conic relief curve, and the effect of one gear relief is better than a pair of gears relief for cubic and sine relief curve. So dynamic simulation on modified involute gears has great significance for reducing contact force of teeth face of gears.