马志先Ma ZhiXian

(副教授)

 硕士生导师
学位:博士
性别:男
毕业院校:哈尔滨工业大学
所在单位:土木工程系
电子邮箱:mazhixian@dlut.edu.cn

论文成果

当前位置: 中文主页 >> 科学研究 >> 论文成果

Experimental investigation on the friction characteristics of water-ethylene glycol mixture flow in internal helical finned horizontal tubes

发表时间:2019-03-11 点击次数:

论文名称:Experimental investigation on the friction characteristics of water-ethylene glycol mixture flow in internal helical finned horizontal tubes
论文类型:期刊论文
发表刊物:EXPERIMENTAL THERMAL AND FLUID SCIENCE
收录刊物:SCIE、EI
卷号:89
页面范围:1-8
ISSN号:0894-1777
关键字:Internal helical-finned tube; Adiabatic; Developing flow; Friction factor; Experiment; Single phase
摘要:Internal helical finned tubes are widely applied in the HVAC field because they enhance convective heat transfer. In this study, an experimental setup was built and used to investigate the single-phase flow characteristics of internal helical-rib roughness covering laminar and transition regimes. The single-phase flow characteristics of two internal helical finned tubes were also determined. The setup contained two test tubes, with nominal diameters of 22.48 and 16.662 mm, number of fins of 60 and 38, helix angles of 45 and 60, and relative roughness values of 0.022 and 0.053, respectively. The Prandtl number varied from 15 to 177, and the Reynolds number ranged from 200 to 36000. Friction factors were accurately measured under the adiabatic condition. Analysis results of the plain tube were in agreement with those obtained using the Filonenko equation. The first critical Reynolds numbers that judged the transition from laminar to transition regimes were 2160 for Tube-1 and 2070 for Tube-2. The second critical Reynolds numbers that judged the start of fully turbulent regime were 14300 for Tube-1 and 9500 for Tube-2. The entrance region influenced the friction factor of helical finned tubes. A correlation was developed to predict the friction factor in the transition regime of helical finned tubes for developing flow.
发表时间:2017-12-01