冯立岩

个人信息Personal Information

教授

博士生导师

硕士生导师

主要任职:Deputy Director of National Research Center of Shipbuilding

性别:男

毕业院校:大连理工大学

学位:博士

所在单位:能源与动力学院

学科:动力机械及工程. 轮机工程

办公地点:大连理工大学西部校区能动楼606

联系方式:0411-84709803

电子邮箱:fengli@dlut.edu.cn

扫描关注

论文成果

当前位置: 冯立岩 >> 科学研究 >> 论文成果

An enhanced multi-component vaporization model for high temperature and pressure conditions

点击次数:

论文类型:期刊论文

发表时间:2015-11-01

发表刊物:INTERNATIONAL JOURNAL OF HEAT AND MASS TRANSFER

收录刊物:SCIE、EI、Scopus

卷号:90

页面范围:857-871

ISSN号:0017-9310

关键字:Vaporization; Multi-component droplet; Radiation absorption; High pressure

摘要:An enhanced multi-component vaporization model was proposed to simulate the vaporization process of fuel droplets under high ambient temperatures and pressures. In the present model, the heat flux of conduction, enthalpy diffusion, and radiation absorption in the gas phase are calculated by Fourier's law, the multi-component diffusion sub-model, and a simplified analytical solution of the radiative heating, respectively. A surface temperature sub-model was employed to evaluate the average temperature within the droplet and the surface temperature of the droplet. For calculation of vapor-liquid phase equilibrium, a real and an ideal gas approach was used for high and low ambient temperatures and pressures, respectively. Moreover, the dependence of gas physical properties on temperature and pressure is also considered. Based on the enhanced vaporization model, extensive verifications for different multi-component droplets were conducted, and the results indicate that satisfactory agreements between the predictions and measurements can be achieved. Finally, the multi-component vaporization model was applied to investigate the vaporization characteristics of practical fuel droplets with a wide range of diameters at high ambient temperatures and pressures, and the effects of radiation absorption and real gas behavior on the vaporization process were understood. It is found that the influence of radiation absorption on the vaporization behavior strongly depends on the droplet diameter and the ambient temperature, and the effect of ambient pressure on the average vaporization rate is determined by the ambient temperature. Considering the compromise between computational accuracy and efficiency, a pressure criterion (P') was introduced for the choice of ideal or real gas approaches, and a diameter criterion (D') was also defined to decide whether to consider the radiation absorption in the vaporization model. (C) 2015 Elsevier Ltd. All rights reserved.