点击次数：

论文类型：期刊论文

发表时间：2014-02-01

发表刊物：POWDER TECHNOLOGY

收录刊物：SCIE、EI、Scopus

卷号：253

页面范围：138-145

ISSN号：0032-5910

关键字：Rotary kiln; Rolling mode; Solid mixing; Active layer; Passive layer; Surface particle motions

摘要：The granular particle motion with rolling mode in rotary kiln is investigated using a three-dimensional mathematical model based on the Euler-Euler two-phase flow and the kinetic theory of granular flow. The mathematical model verified by comparing with the published experimental data is used to simulate performance of an inclined rotary kiln. The angle of inclination and the residence time of particles in rotary kiln are taken into account. The active layer thickness can be calculated by observing the particle velocity change from positive to negative values. The stagnation point at the bottom of the free flowing zone is the interface between the active layer and the passive layer. Simulations show that the active layer of the charge end of the rotary kiln is thin and particle velocity is low. With the increase of axial distance, the active layer thickness and velocities of granular particles increase respectively, the thickness of the active layer and velocities of particles close to the discharge end of the rotary kiln decrease. A fourth-order polynomial velocity profile can be obtained from the numerical simulation results. Apart from providing a computationally efficient tool to simulate kiln performance, the results discussed here will provide a useful basis for the development of comprehensive three-dimensional models of rotary kilns. (C) 2013 Elsevier B.V. All rights reserved.