Personal HomePage

+

Li Yaopeng

Recommended Ph.D.Supervisor Recommended MA Supervisor

Personal Information

Supervisor of Doctorate Candidates

Master Tutor

Gender:Male

Alma Mater:大连理工大学

Degree:Doctoral Degree

School/Department:能源与动力学院

Discipline:Power Engineering and Engineering Thermophysics

Business Address:能源与动力学院809室

E-Mail:liyaopeng@dlut.edu.cn

Numerical study on the combustion and emission characteristics of a methanol/diesel reactivity controlled compression ignition (RCCI) engine

Date:2019-11-04  Hits:

Indexed by:期刊论文

Journal:APPLIED ENERGY

Included Journals:SCIE、EI、ESI高被引论文

Volume:106

Page Number:184-197

ISSN No.:0306-2619

Key Words:Methanol/diesel dual-fuel; Reactivity controlled compression ignition (RCCI); Methanol mass fraction; Start of injection (SOI)

Abstract:An improved multi-dimensional model coupled with detailed chemical kinetics mechanism was applied to investigate the combustion and emission characteristics of a methanol/diesel reactivity controlled compression ignition (RCCI) engine. The fuel was supplied separately by directly injecting diesel fuel into cylinder well before top dead center, while premixing methanol through the intake port in the tested methanol/diesel RCCI engine. The effects of mass fraction of premixed methanol, start of injection (SOI) of diesel and initial in-cylinder temperature at intake valve closing (IVC) on engine combustion and emission were investigated in detail. The results show that both methanol mass fraction and SOI have a significant impact on cetane number (CN) distribution, i.e. fuel reactivity distribution, which determines the ignition delay and peak of heat release rate (HRR). Due to larger area with high-temperature region and more homogeneous fuel distribution with increased methanol, and the oxygen atom contained by methanol molecule, all the emissions are reduced with moderate methanol addition. Advanced SOI with high combustion temperature is favorable to hydrocarbon (HC) and soot reduction, yet not to the decrease of nitrogen oxide (NOx) and carbon monoxide (CO) emissions. Both increasing methanol fraction and advancing the SOI are beneficial to improve fuel economy and avoid engine knock. Moreover, it was revealed that the initial temperature must be increased with increased methanol fraction to keep the 50% burn point (CA50) constant, which results in decrease of the equivalent indicated specific fuel consumption (EISFC) and all emissions, except for slight increase in NOx due to the higher burning temperature. (C) 2013 Elsevier Ltd. All rights reserved.

Date of Publication:2013-06-01

Pre One:Parametric study and optimization of a RCCI (reactivity controlled compression ignition) engine fueled with methanol and diesel Next One:Numerical evaluation of the potential of late intake valve closing strategy for diesel PCCI (premixed charge compression ignition) engine in a wide speed and load range