Hits:

Indexed by:Journal Papers

Date of Publication:2020-03-01

Journal:INTERNATIONAL JOURNAL OF ADVANCED MANUFACTURING TECHNOLOGY

Included Journals:SCIE

Volume:107

Issue:5-6

Page Number:2757-2765

ISSN No.:0268-3768

Key Words:Abrasive waterjet; Monolithic abrasive; Mixing abrasives; Cutting ability; Cutting quality

Abstract:In abrasive waterjet (AWJ) process, abrasive properties are of critical factors that influence machining performances. Abrasive process parameters including abrasive material, size and flow rate, exert a significant impact on cutting ability and quality of AWJ. In this paper, monolithic abrasive material (garnet, alumina and silicon carbide) and corresponding mixing abrasive materials are adopted to evaluate the effect of abrasive process parameters on the cutting ability and quality, respectively. Two kinds of cutting experiments are conducted with a monolithic abrasive to explore the influence of variation in abrasive material, size and flow rate on the machining performance. The cutting depth experiments for evaluating the cutting ability in terms of cutting depth are conducted with a right trapezoid aluminium alloy block. The kerf cutting experiments are taken to evaluate the cutting quality by the kerf taper angle, kerf width and surface roughness. On this basis, AWJ experiments with mixing abrasive materials are taken to probe into the composition of mixing abrasives' effect on cutting performance. It is found that the abrasives consisting of 75% alumina and 25% garnet in mass fraction lead to a maximum cutting depth of 41.7 mm and the smallest surface roughness of R-a 2.1 mu m under the flow rate of 130 g/min.