杨明军Mingjun Yang

(教授)

 博士生导师  硕士生导师
学位:博士
性别:男
毕业院校:大连理工大学
所在单位:能源与动力学院
电子邮箱:yangmj@dlut.edu.cn

论文成果

当前位置: 中文主页 >> 科学研究 >> 论文成果

Effects of additives on continuous hydrate-based flue gas separation

发表时间:2019-03-12 点击次数:

论文名称:Effects of additives on continuous hydrate-based flue gas separation
论文类型:期刊论文
发表刊物:APPLIED ENERGY
收录刊物:SCIE、EI、CPCI-S、Scopus
卷号:221
页面范围:374-385
ISSN号:0306-2619
关键字:Hydrate-based gas separation; Carbon dioxide hydrate; Additives; Continuous experimental process; Solution movement
摘要:CO2 capture from fossil fuel power plants is the main method of CO2 storage. Hydrate-based gas separation is regarded as a potential method for CO2 capture from flue gas. In this study, hydrate-based gas separation (HBGS) was used to capture CO2 from flue gas (19.96 mol% CO2 and 80.04 mol% N-2), and the continuous experimental process was monitored using magnetic resonance imaging (MRI). The effects of two additives (5 vet% TBAB + 5 wt% TFIF and 19 wt% THF), two gas injection methods (constant pressure and constant flow rate processes), and of different pressures and flow rates on the hydrate saturation and solution movement were investigated. The results show that both additives effectively promote hydrate formation. The constant pressure process was superior to the constant flow rate process for hydrate formation. Furthermore, the flow rate had little influence on the hydrate saturation. The process was most efficient when a hydrate formation stage time of approximately 80 min was used. The solution movement resulting from the continuous multiple cycles tended to decrease during subsequent cycles. Moreover, the addition of 19 wt% THF had a more obvious effect on the solution movement than 5 wt% TBAB + 5 wt% THF. Solution concentration phenomena were observed in the presence of 19 wt% THF at 285.15 K; these phenomena may have been affected by the formation and dissociation of hydrates. Due to solution movement during the continuous industrial hydrate-based gas separation process, the solution might need to be replenished. Finally, in terms of the resulting the hydrate saturation, the use of 5 wt% TBAB + 5 wt% THF was found to be more suitable in this study, while the 19 wt% THF was more suitable for a higher experimental temperature.
发表时间:2018-07-01