location: Current position: Home >> Scientific Research >> Paper Publications

Decoration of Si-nanowires-grafted Si micropillar array with Ag nanoparticles for photoelectrocatalytic dechlorination of 4-chlorophenol

Hits:

Indexed by:期刊论文

Date of Publication:2016-01-01

Journal:RSC ADVANCES

Included Journals:SCIE、EI

Volume:6

Issue:82

Page Number:78564-78569

ISSN No.:2046-2069

Abstract:Use of Si materials as photoelectrodes in aqueous solutions is fundamentally required to inhibit the formation of an insulating SiO2 layer as well as promote the transfer of photogenerated holes and electrons from the interior of Si to the solid-liquid interface. In order to meet these requirements, an Si material, with hierarchical structure and Si nanowires standing on the surface of Si micropillar array (SiNW/SiMP), was prepared for facilitating the transfer of photogenerated carriers to the solid-liquid interface. Decoration of SiNW/SiMP by Ag nanoparticles (Ag/SiNW/SiMP) via depositing Ag nanoparticles on the surface of SiNW/SiMP successfully restrained the generation of SiO2 through preventing the contact of SiNW/SiMP with water. Pristine SiNW/SiMP photocathode exhibited enhanced photoelectrochemical activity with a photocurrent of approximately -31 mA cm(-2) at -1 V (vs. SCE), which was about one order of magnitude larger than that of SiMP; however, the photocurrent decayed with prolonged illumination. By comparison, Ag/SiNW/SiMP photocathode exhibited stable photocurrent of approximately -37.5 mA cm(-2) at -1 V (vs. SCE) during 10 cycles of CV testing, which was 21% higher than that of the pristine SiNW/SiMP. Ag/SiNW/SiMP photocathode exhibited excellent photoelectrocatalytic activity towards dechlorination of 4-chlorophenol (4-CP). Over 95% of 4-CP (initial concentration of 10 mg L-1) was rapidly degradaded after 20 min, which were 3 and 1.1 times higher than those of the SiMP and SiNW/SiMP. The good reproducibility was verified by the results of six consecutive experiments.

Pre One:abrication of TiO2 nanofiber membranes by a simple dip-coating technique for water treatment

Next One:Fabrication of pilot-scale photocatalytic disinfection device by installing TiO2 coated helical support into UV annular reactor for strengthening sterilization