location: Current position: Home >> Scientific Research >> Paper Publications

Effects of heat treatment on shape-setting and non-linearmechanical properties of Nitinol Stent - art. no. 64233N

Hits:

Indexed by:会议论文

Date of Publication:2007-07-01

Included Journals:EI、CPCI-S、Scopus

Volume:6423

Page Number:N4233-N4233

Key Words:niTi shape memory alloy; shape-setting treatment; stent; transition temperature; superelasticity

Abstract:NiTi shape memory alloy is a temperature sensitive material with non-linear mechanical properties and good biocompatibility, which can be used for medical devices such as stent, catheter guide wire and orthodontic wire. The majority of nitinol stents are of the self-expanding type basing on the superelasticity. Nitinol stents are shape set into the open condition and compressed and inserted into the delivery catheter. Additional the shape-setting treatment can be used as a tool to accurately tune the transformation temperatures and mechanical properties. In this study, different heat treatments have been performed on the Ti-50.7at%Ni alloy wires. And results of shape-setting, austenite transformation finish temperature and non-linear mechanical property of NiTi shape memory alloy at body temperature have been investigated. The experimental results show that the proper shape-setting temperature should be chosen between 450-550 degrees C. And the shape-setting results were stabilization when the NiTi wires were constrain-treated at 500 and 550 degrees C and ageing time longer than 10 minutes. The austenite finish temperatures increased with ageing time and increased first and then decreased with ageing temperature. The peak values were obtained at 400 degrees C. When the heat treatments was performed at the same temperature, both the upper plateau stresses and lower plateau stresses decreased with the ageing time. Most of treated nitinol wires owned good recovery ability at body temperature and the permanent sets were less than 0.05% when short time ageing treatment was performed at 500 degrees C.

Pre One:晶粒尺寸及织构对热挤压AZ31镁合金室温压缩变形行为的影响

Next One:Morphology and interface characteristics of ZnO films deposited at room temperature and 750 degrees C