location: Current position: Home >> Scientific Research >> Paper Publications

Nanoscale machinability and subsurface damage machined by CMP of soft-brittle CdZnTe crystals

Hits:

Indexed by:期刊论文

Date of Publication:2010-04-01

Journal:INTERNATIONAL JOURNAL OF ADVANCED MANUFACTURING TECHNOLOGY

Included Journals:SCIE、EI、Scopus

Volume:47

Issue:9-12,SI

Page Number:1105-1112

ISSN No.:0268-3768

Key Words:Chemical mechanical polishing; Nanoscale machinability; Subsurface damage; Soft-brittle crystal; CdZnTe

Abstract:Nanoscale machinability and subsurface damage induced by chemical mechanical polishing of three kinds of single crystals were investigated by nanoscratch and high-resolution transmission electron microscope (HRTEM). When the constant loads increase from 800 mu N to 3,200 mu N, the friction coefficient adjacently linearly increases from 0.199 to 0.292, due to the surface machining hardening effect. As the slight wiping on the surface of Cd(0.9)Zn(0.1)Te (111) leads to microscratches, the surface turns worse, resulting in the decrease and fluctuation of friction coefficient. Shear band appears on the surface of Cd(0.96)Zn(0.04)Te (111), while it disappears on the surfaces of Cd(0.96)Zn(0.04)Te (110) and Cd(0.9)Zn(0.1)Te (111), replacing with more obvious plastic flow pile-up, and showing the better nanoscale machinability. The cross-sectional HRTEM images show that after CMP the damage layer is 2 nm, and only consists of amorphous state, indicating the main material removal mode of chemical dissolving. While after lapping and mechanical polishing, wear track with width of about 50 nm is still left on the machined surface, and subsurface damage layer is about 10 nm.

Pre One:Phase transformation of single crystal silicon induced by grinding with ultrafine diamond grits

Next One:Subsurface crystal lattice deformation machined by ultraprecision grinding of soft-brittle CdZnTe crystals